Jump to: navigation, search

Difference between revisions of "Batch Mode (Running Experiments)"

Line 25: Line 25:
  
 
[[Image:Exper1a.png]]
 
[[Image:Exper1a.png]]
[[Image:Exper1b.jpg|300px]]
+
[[Image:Exper1b.png]]
  
 
'''Figure 1a,b:''' Creating a new modifier for a particular disease in an existing scenario
 
'''Figure 1a,b:''' Creating a new modifier for a particular disease in an existing scenario

Revision as of 16:28, 30 September 2009

STEM TOP BAR.gif

Overview

The purpose of Experiments is to allow running a set of scenarios, one after another, each modifying some aspect of a "base" scenario. As an example, suppose you do not know the transmission rate for a disease. One can set up an experiment that varies the transmission rate through a range of values and the result for each run can be analyzed (via log files).

STEM uses components called "Modifiers" to modify the base scenario from one run to the next. A modifier is attached to another component in your scenario. for instance a disease model or a infector. The modifier is responsible for changing one or more attributes of the attached component between runs.


An experiment is a collection of modifiers with a link to a scenario, and an experiment can run just like a scenario can run. When you run an experiment it creates a batch that will spawn off (a sequence of) simulations.


New View: Active Batches (Analogous to Active Simulations)

1) Create your scenario.

2) In the editor you can create modifiers for models, decorators (a disease model), or graphs. To create a modifier for a disease, for example, find your disease in the STEM Project Explorer. Select it, right click on your disease, and chose create a modifier as shown in Figure 1.


Exper1a.png Exper1b.png

Figure 1a,b: Creating a new modifier for a particular disease in an existing scenario


This will launch a new dialog to help you create a modifier that can be added to an experiment (see Figure 2). In the new modifier dialog, for example, under Transmission rate select "range" (sequence not yet enabled) and specify the range as shown in Figure 2.


3) On top, select "Experiment Model" to launch the experiment wizard (Figure 2). Drag the scenario into the experiment. Drag any number of modifiers into the experiment.

Click on the experiment, right click, and run it.

Exper2.jpg Figure 2: The New Experiment Wizard.


Save your work at this point by hitting ctrl-s


You run an experiment the same way you run a scenario. In the STEM Project Explorer click on the experiment, right click, and select run.